How do I reset my Cisco access point to factory settings?
How do I reset my Cisco access point to factory settings?
Reset Cisco Wireless AP to factory defaults
- Connect the console cable.
- Unplug the power or network cable if connected to a POE switch.
- Press and hold the Mode button.
- Plug the power back into the AP.
- Wait until the output on the console says button is pressed.
How do I manually reset my Cisco router?
Reset Router Using Reset Button
- With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
- Find the Reset button on the router.
- Press and hold the Reset button while you power on the router.
- Release the Reset button after 10 seconds.
How do I Reset my Cisco Aironet 1142?
Factory Reset via MODE Button Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.
Where is the reset button on a Cisco router?
Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.
How do I clear the running config on a Cisco router?
To clear out the running config file, simply erase the startup config file and then reload the device.
How do I reset my WAP?
Resetting the access point using the Reset button Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid.
How to hard reset air-ap1242ag-a-k9 router-default login?
The Cisco AIR-AP1242AG-A-K9 router has 54mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports. It is also known as the Cisco Cisco Aironet 802.11a/b/g Access Point. 1. When the router is on, press the button reset and hold for 30 seconds.
How do I Reboot my Cisco Aironet 1242ag?
Hold the MODE button until the Status LED turns amber, and then release the button. The Status LED turns amber in approximately 1 to 2 seconds. After the AP reboots, reconfigure the AP and use the web browser interface, the Telnet interface, or Cisco IOS Software commands.
When does Cisco air lap1252ag-k9 factory reset happen?
*Mar 1 00:47:34.815: %CAPWAP-3-ERRORLOG: Invalid event 38 & state 2 combination. Community Live- Application Hosting on ISR, ASR, CSR and Cat… Community Live-Application Hosting on ISR, ASR, CSR and Catalyst Routing Platforms This event will have place on Tuesday 20th, July 2021 at 10:00 hrs PDT Register Today!
How can I Reset my Cisco air lap?
I have the password. Holding down the mode button while the access point is booting does not seem to do the trick. Solved! Go to Solution. 11-08-2013 11:08 PM 11-08-2013 11:08 PM